Nanoplasty for blonde from Viure Expertise Gloss Biomix Platinum 1l

Viure Biomix. Hair nanoplasty. NEW!!!
☝Designed specifically for blonde, with a purple tint.

Viure Bio Mix🌿 is a real lifesaver for hair that needs
maximum treatment.
Contained in the extract of wheat and soybeans with the addition of amino acids, serine and threonine, arginine, avocado oils, aloe vera and lotus extracts, Bio Mix smoothes hair, gives it a well-groomed appearance, heals, penetrating into the hair structure.

Application method:

1. Gently wash your hair with a deep cleansing shampoo. Try not to rub the shampoo into your scalp. Wash away. If the hair does not become stiff after the first wash, you can repeat the procedure, leaving the shampoo on the hair for a few minutes.

2. Dry your hair (without combing) to remove approximately 80% moisture - this will ensure the best penetration of the composition into the hair structure.

3. Shake the bottle well and pour the required amount of compound (Step 2) into a plastic container.

4. Approximate consumption of the composition

15-25 ml - short hair

25-45 ml - medium length hair

45-70 ml - long hair

5. Divide your hair into four sections. Be sure to use protective gloves.

6. Apply the composition (Step 2) to the hair, retreating about 1 cm from the roots. Use a paint brush. Distribute the composition evenly over the entire length of the hair. Make sure all hair is covered.

7. Comb your hair with a comb, do not allow excess composition.

8. Let the compound soak in for 15 to 30 minutes. Check if the hair is not oxidized, then support another 10-15 minutes. How to check the hair for oxidation: just pull the strand, if it stretches a little, then the hair is oxidized.

9. Rinse the composition from the hair with warm water.

10. Apply Step 3 Deep Mask and leave on hair for 5-10 minutes.

11. Wash off the mask with water.

12. Blow dry your hair 100%.

13. Set the ironing temperature to 190 -230 degrees. Please note that Biomix nanoplastic is specially designed for damaged hair, so we raise the temperature only if we are sure that it will suit the hair. We always start at the lowest temperature!

14. Part your hair and iron 10 to 15 times each section, depending on your hair type. This is the most important part of the process. Use a professional flat iron.

15. Stretch the hair evenly, without stopping, so as not to burn the strand. The first 5 times, pull a little slower to make sure that the product penetrates deep into the cuticle.

Ps: after nanoplasty, you can do staining after 2 days.

Clarification not earlier than after 2 months.

You will find more detailed information, video on our Telegram channel https://t.me/beautybrazilnet